![]() You can use the “Easy Setup” to “Scan New List” and find a new free frequency. ![]() If you see RF activity on the display meter with the transmitter powered off, it means that there is another signal on the same frequency interfering with your system (most likely from a TV station). When the transmitter is powered off, the receiver no longer hears the transmitter and tries to latch onto any signal it can find on that same frequency. When the transmitter is on, everything is working just fine because of the close proximity of the trans- mitter and receiver. This simply means you are on a frequency which is already in use, most likely by a television station. Why does my PA system or camera emit a horrible loud static noise when I power off my transmitter? If you want to use a unit that does not do this, buy a Shure, MiPro, etc Most of these will not pass interference when the transmitter is off.If the unit is set up correctly you should not get interference. Even with the Pilot on, when the transmitter is off, Sennheiser does not mute their outputs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |